Each geographic area has its own types of construction materials that are popular and effective for that locale. If no condensation appears under the plastic after 48 hours the floor is likely dry enough to paint. It will also make the concrete smoother by forcing larger pieces of aggregate down and bringing a liquid mix of small sand and cement particles to the surface.
This one may seem self-explanatory, but often someone will begin mixing the concrete prematurely resulting in the concrete beginning to harden prior to placing it where it needs to go. A better method is to make sure all materials are present and any spreading or moving tools are also present and ready before mixing the concrete.
While drilling holes into residential concrete contractors albuquerque nm it is advisable to drill in water or have a water pipe or a shower of water over the drilling area as concrete drilling generates a lot of heat. With acid stains we'll often use a resist - a clear sealer - that we apply with a sea sponge or rag, then come over it with the stain.
For me stains are similar to watercolors. Adding water to stain mixed in acetone will allow the stain to not dry or flash off" as quickly when staining. Sweeping it in overlapping arcs will fill any small holes left by screeding and level the surface. Avoid finishing concrete with bleed water still on the surface.Have sufficient manpower to manage the concrete when it is being poured and for the finishing process. Also do not get the concrete mix too wet as this can reduce strength and make it less able to withstand weathering. On the other hand, a bucket of cold water and a sponge will work for sandstones, granite, concrete, brick and marble surfaces.;